Unlabelled How To Flashing elephone m2

Tuesday, February 14, 2017

How To Flashing elephone m2

    No comments


keyword : How To Flashing elephone m2 for bootloop , How To Flashing elephone m2 for softbrick , How To Flashing elephone m2 for hardbrick , How To Flashing elephone m2 Error Camera , How To Flashing elephone m2 blank screen , How To Flashing elephone m2 lost password , How To Flashing elephone m2 stuck logo , How To Flashing elephone m2 new 2017. How To Flashing elephone m2 repair phone.




Download one of the above file:


Further to the next stage
1. Copy the file to Sd Card
2.boot into recovery mode, in the file already exists in the form of .pdf open a full tutorial and follow the instructions. anyone using flashing software.
3. When've followed all of the conditions please check the phone has been normal what is not.
4.Ciri EMMC feature of flashing not damaged in the road, still can wipe data cache. but install the update form sd card can not or will not runing.
5.booting first after install rom fair amount of time of approximately 15 minutes. Do not hurry to remove the battery. wait until the system finishes booting.

important: before doing anything on the phone to do the data backup beforehand. can pass CMW, recovery, twrp please find if you have not got.

How To Flashing elephone m2

put the waterproof sticker around the ear speaker mesh. the original screen has a gap here. now i'll put something to stuff it and put on sticker. put the sticker on the sides of lcd supporting frame. just like the picture showed. put it on the sides. put on the lcd sticker. make it adhesive to the frame. then put the waterproof sticker on the sides, above the screen sticker.

assemble the screen. use elastics to make it adhesive well. keep it for at least 15 mins. put the sticker on these three parts. put it around the side. put back the charging port. hold it at least 90 seconds to set it well. put back second mic, and keep it for 90 secs. put back headphone set, keep it for 90 secs.

put the sticker around the mic mesh. and put it back. down the ear speaker. on these three parts on the mic mesh. and down the mic mesh. put the sticker around the loudspeaker. keep it for at least 90 seconds. put the indicator sticker on the screws.

put on the back cover sticker. put waterproof sticker on the back cover sticker. then put some on the inside of the back cover sticker. put back the back cover. clean up the water. heat up the back cover. focus on the bottom. use plastic card to open it. it's very adhesive.

first remove the battery. clean up the sticker. see? these indicators are white. remove the motherboard. indicators here? white! let's see what happen down the motharboard. remove the earpiece. white! now let's take a look at this part.

clean up the sticker above. and remove the loudspeaker. remove the microphone board. check the mic mesh.

No comments :

Post a Comment

Subscribe to: Post Comments ( Atom )