Unlabelled How To Flashing wiko pulp fab 4g

Tuesday, July 4, 2017

How To Flashing wiko pulp fab 4g

    No comments


keyword : How To Flashing wiko pulp fab 4g for bootloop , How To Flashing wiko pulp fab 4g for softbrick , How To Flashing wiko pulp fab 4g for hardbrick , How To Flashing wiko pulp fab 4g Error Camera , How To Flashing wiko pulp fab 4g blank screen , How To Flashing wiko pulp fab 4g lost password , How To Flashing wiko pulp fab 4g stuck logo , How To Flashing wiko pulp fab 4g new 2017. How To Flashing wiko pulp fab 4g repair phone.




Download one of the above file:


Further to the next stage
1. Copy the file to Sd Card
2.boot into recovery mode, in the file already exists in the form of .pdf open a full tutorial and follow the instructions. anyone using flashing software.
3. When've followed all of the conditions please check the phone has been normal what is not.
4.Ciri EMMC feature of flashing not damaged in the road, still can wipe data cache. but install the update form sd card can not or will not runing.
5.booting first after install rom fair amount of time of approximately 15 minutes. Do not hurry to remove the battery. wait until the system finishes booting.

important: before doing anything on the phone to do the data backup beforehand. can pass CMW, recovery, twrp please find if you have not got.

How To Flashing wiko pulp fab 4g

with the spudger, take off the back case of the phone now, take off the battery with a philipps ph00 screwdriver unscrew the internal frame of the phone there are 12 screw in total do not forget the white screw at the top right corner it is hidden by a white sticker you can now take off the internal frame by using the isesamo tool

we are now working on the lcd for that we are using a heat gun to soften the glue all around the glue now softened take off the lcd from the frame with the isesamo tool we must now remove glue residue on the frame you can for that use isopropyl alcohol ipa 170 a spuder, spatulas, and why not plastic razor blades

as on the image, we will apply 3m double sided tape we are using 1mm for the side and 3m for the top and bottom of the screen for perfect angles, prefer fine-pointed scissors with a spudger, we apply a little pressure on the double sided tape in order to obtain a good adhesion to the device now remove the protective strips install your new lcd screen insert the two flex into the holes provided for this purpose

then, apply a slight pressure on the contour of the device after pluggin the two flex on the motherboard we put back the internal frame then we apply a pressure all arround until you hear a click on each anchor point finaly, we screw on all do not forget, the screws are commutable

No comments :

Post a Comment

Subscribe to: Post Comments ( Atom )