Friday, April 14, 2017

How To Flashing lenovo a6000

  No comments


keyword : How To Flashing lenovo a6000 for bootloop , How To Flashing lenovo a6000 for softbrick , How To Flashing lenovo a6000 for hardbrick , How To Flashing lenovo a6000 Error Camera , How To Flashing lenovo a6000 blank screen , How To Flashing lenovo a6000 lost password , How To Flashing lenovo a6000 stuck logo , How To Flashing lenovo a6000 new 2017. How To Flashing lenovo a6000 repair phone.




Download one of the above file:


Further to the next stage
1. Copy the file to Sd Card
2.boot into recovery mode, in the file already exists in the form of .pdf open a full tutorial and follow the instructions. anyone using flashing software.
3. When've followed all of the conditions please check the phone has been normal what is not.
4.Ciri EMMC feature of flashing not damaged in the road, still can wipe data cache. but install the update form sd card can not or will not runing.
5.booting first after install rom fair amount of time of approximately 15 minutes. Do not hurry to remove the battery. wait until the system finishes booting.

important: before doing anything on the phone to do the data backup beforehand. can pass CMW, recovery, twrp please find if you have not got.

How To Flashing lenovo a6000

hi guys, today faced a problem in lenovo k30w, they also k30t, they also a6000. the problem of blinking display what can you think? replacing the display. as a result, the display changed. the display also blinks quite lost in conjectures, we thought that even replace the firmware but then i found a little interesting point on the board there is ...this element it is very hot now i show the video where it boils

that's what it boils here's a charm and immediately starts to behave inadequately display, so here is blinking i thought not soldered well, but it was defective chip find a solution to the problem, set the heat-conducting rubber as a result, everything is fine the heat will be distributed to the entire board "thanks" to the company lenovo

No comments :

Post a Comment